My van is a 2007 2.3 120 Ducato with 205,000 miles on the clock. She used to run as sweet as a nut. Last week I got the dreaded power dropping out whilst cruising down the motorway. Engine management light came on and sure enough it was the classic P0638 Throttle Actuator Control Range/Performance. Purchased a new throttle body along with the

Fiat Ducato Mk3 Check Engine warning light - the engine warning light (also known as check engine light) is very important, and if illuminated it should be dealt with as soon as possibe. The most likely cause of the engine light on your dashboard is a sensor of some kind. It could be a camshaft, crankshaft, O2, MAP, or MAF sensor.

Brief recap: 1) Start/Stop Unavailable message. 2) a few weeks later, the message returned with the addition of the car going in to limp mode for the afternoon. On my follow up visit after #2, the technician said that there was no code showing up that corresponded (if that's the right word) with the limp mode event.
I have a 2013 Fiat Ducato based MH with a 150 Multijet engine and around 25,000 miles on the clock. We had been away a few days when on an initial start up in the morning a message appeared –'EBD failure – see handbook' and 'ABS unavailable – see handbook'. I checked under the bonnet (oil, fluids, etc) and under the vehicle but couldn't Two lessons learned. 1. Top up Adblue regularly in future, don’t wait for the warning lights, (although, according to the handbook, when the light comes on there is still enough for 1.5k miles). 2. We won’t buy another motorhome based on a Peugeot chassis.
How to reset the dual zone climate of the Fiat Bravo. If the two-zone electronic climate control system is installed on your Fiat Bravo and it happens that it does not respond correctly to the commands, or that it does not respect the temperature differences set by the driver and the passenger, it may be due to the fact that it is not able to control the opening vanes perfectly. and closure of
sensor failure The warning light comes on when the engine. oil pressure sensor is faulty. Contact Fiat Dealership as soon as possible." when the car is running without the lights on this warning light does not come on! I just want to make sure its not something simple like a loose connection before i go to the dealership with it. 2. Feb 17, 2015. #1. Hi all, 35 160 M-Jet / 3.0 / Auto / 2008. I have been getting "Check Glow Plugs" alert when starting and the glow plug symbol flashes for a few minutes after starting. I'm new to this vehicle, and to diesel engines, but quite experienced on petrols.. so basically know what's going on.. However, I have done some exploratory

Hold press the button for the countdown time. After that remove the key contact and replace it for start the engine. If the manipulation has worked the daily counter should normally be reset to zero. If the drain indicator light is still on, perform the following procedure: Switch on of your Fiat Ducato but without starting the engine in the

The best thing to do is to put a voltmeter across the battery. Before engine start a fully charged battery should be about 12.5v. With the engine running it should be around 13.5-14v. Some new motorhomes use regenerative systems where the voltages may be lower for short periods with the engine running but if the alternator is serviceable there
Fiat Ducato Engine Fault There are hundreds of reasons why the check engine warning fault light comes on, and only your dealer or mechanic is qualified to address this. Common reasons include a loose fuel cap, excess vibration, a blocked cylinder, a bad fuel mix, excessive heat and half power.
Grumpa1 said: Thanks for reply, been and had a chat with one of my old buddies who’s is now a Fiat mechanic, he gave me instructions on how to reset the brake light switch from a 2015 Fiat bulletin ( Ducato 290 brake pedal switch DTC C1215 ) it resets the internal switch position. Take hold of the switch turn clockwise by 45 degrees until it
I have a Fiat Ducato based motorhome, bought new September 2009, with 3lt engine and Comfortmatic gearbox. My problem started in January 2011 when taking the vehicle for its monthly off-season run. When I started the engine I got a warning bleep, a message stating 'Check Transmission' and the gearbox warning light was illuminated.
As for how long it takes for a Check Engine Light to reset, anywhere from a few days to several weeks. How far you have to drive to reset the Check Engine Light may be a better question – It’s usually no more than 30 miles. If the light doesn’t clear by then, you should definitely look into the problem more closely, your search isn’t over.
nlHtzC.
  • bphfhl2aoj.pages.dev/317
  • bphfhl2aoj.pages.dev/52
  • bphfhl2aoj.pages.dev/562
  • bphfhl2aoj.pages.dev/93
  • bphfhl2aoj.pages.dev/72
  • bphfhl2aoj.pages.dev/317
  • bphfhl2aoj.pages.dev/533
  • bphfhl2aoj.pages.dev/381

    • fiat ducato check engine light reset